HOW TO: MiniRooms and Accessories

MiniRooms and Accessories

Forge & Tinker MiniRooms are modular and expandable and are compatible with many of our accessories. Below is some information on how to assemble, expand, adjust and use your MiniRooms and other Forge & Tinker accessories.

If you have any other questions about setting up and using your MiniRooms or accessories, please email us at team@forgeandtinker.com

Assembling Basic MiniRooms

Adding Magnetic Posters to Your MiniRoom

Adding Magnet Windows to Your MiniRoom

Assembling Two Wall MiniRooms ( coming soon )

Joining Multiple MiniRooms Together ( coming soon )

Adding Electric Powered Accessories ( coming soon )

Assembling Basic MiniRoom

MiniRooms may contain floor modules and wall modules. These can be configured in various ways to make any layout you would like. The most basic MiniRoom configuration is one floor and one wall. To install a wall onto a floor, start with the floor sitting flat on a table or other flat surface so that you can clearly see and reach the upright brackets at the back of the floor.

The rear braces on the wall will be inserted into the brackets at the back of the floor and the printed surface of the wall will slide between the back edge of the floor and the front face of the bracket.

Gently push down until the wall is full seated into the floor. The metal wall should be resting on top of the foot of the bracket.

 Adding Magnetic Posters to Your MiniRoom

Our Magnetic Poster accessories have a small metal disk on the back. You can place the poster on the wall and then place the included magnet  on the back of the wall to hold it in place. To avoid scratching your walls you should place the poster where you want it and then add the magnet. Do not slide the poster on the wall, especially when the magnet is in place.

Adding Magnetic Windows to Your MiniRoom

Our Magnetic Window accessories have two components. The first is the frame which has four magnets, one in each corner. The second component is the view which is the same as one of our Magnetic Poster accessories and has a metal disk on the back.

The easiest way to place a window is to first place the view as you would a poster. Place it on the wall where you want the window to be located and then place the included magnet on the back of the wall behind it. Be sure to place the view where you want it before adding the magnet. Do not drag the view or the window on the wall because this may scratch the wall. 

The next step is to place the window frame over the view. Once in place, you can add the four included magnets to the back of the wall. They should snap in place over each corner magnet and will securely hold the window frame to the wall. Once again, do not drag the window as this may scratch the wall. To reposition, remove the magnets, move the window frame and view and then replace the magnets.

If you have any other questions about setting up and using your MiniRooms or accessories, please email us at team@forgeandtinker.com